Superselect transmission oil problem
Good morning, I'm new to the forum.
I have a Mitsubishi Io 2.0 GDI 4G94 with a Superselect transmission.
The problem I have is that oil is leaking from the gearbox through the retaining ring on the rear transmission shaft output.
I took it to a workshop and they replaced an inner bearing, the retaining ring itself and the tip of the transmission shaft that meshes with the inside of the transfer case.
It's been like this for a while and they haven't given me any solution to the problem.
Has anyone else had this problem and been able to solve it?
Best regards
Hola, Gracias por
Hola,
Gracias por responderme.
La fuga esta en el retén de aceite (pieza nº 31). Como indicó, esa pieza cambió varias veces, así como muchas piezas del interior del transfer e incluso un transfer nuevo, pero el problema persiste.
También cambiaron diferentes piezas que podrían afectar de forma indirecta al funcionamiento del eje de transmisión, como los soportes del motor o los amortiguadores del eje trasero.
En este punto, me he quedado sin ideas...
OK so if is coming from seal
OK so if is coming from seal #31 and it has been changed numerous times then the shaft on the drive shaft that slides in against the seal might be damaged. Also you might want yo check the breather for the transfercase is not blocked. It could be not allowing it the breath when getting hot and pushing out the oil.
Syndicate
Hi Yah There is normally a
Hi Yah
There is normally a large seal on the transfercase output case which seals against the drive shaft when inserted....
Throw up a picture of the area and where the leak is comming from....
Snip from manual
Cheers
Calvin
Calvin Tyler
1998 Paj IO
Auckland, NZ